Features of Allergic Harvest PC

The thickness of this material is 4 mm.

If you would like, you can raise the period of the construction to 6 metres or more. To try it, it is sufficient to attach a two-meter expansion. When selecting a drawing, pay attention to the space between the arches. This figure needs to be 65 cm, which is the most appropriate length for the specified depth of this substance. The diameter of the doors based on the maker’s drawing is 90 cm.

Before building a polycarbonate greenhouse, then it is necessary to pick a spot for the location. If this is done properly, it is possible to provide yourself with a harvest of fresh vegetables for the whole year.

The place for the upcoming greenhouse is marked instantly in the planning of the garden plot. So as to melt the snow in the location of the greenhouse as soon as possible, the very best point on the site is going to be a small elevation. Additionally, in this location is not going to have to be worried about large humidity as soil and air within the construction.

Build a polycarbonate greenhouse in an elevated site – means to look after the optimal temperatures indoors.

If it is not possible to put a greenhouse in an elevated place, you will need to pour a coating of fine shattered rock around 20 cm and the exact same layer of fertile soil to create seedbeds.

Before assembling a greenhouse on your backyard plot, you should also think about where and how this construction will be set up. To begin with, you must choose a place for this. The greenhouse should be found in a well-lit area at least a few meters away from houses, barns and other structures.

The best way to Put in a greenhouse Based on the Faces of the world

Be sure to level the soil surface – it is best to remove the top layer. This can also get rid of weed seeds. And for ease of work, eliminate the dirt in an area that’s going to a meter wider on each side of the rectangle you want.

It’s also worth thinking about using a base. As manufacturers state, today most greenhouses don’t need it, particularly if they (greenhouses) are employed only in the summer and spring time. But, seasoned anglers still recommend making at least a basic basis from a pub. It’s quite simple – it is sufficient to link with each other utilizing metal screws and corners four pieces of wood using a cross-section of at least 10 * 10 cm. The size of such a base ought to be equivalent to the base of their upcoming greenhouse.

Simple bar base

You might even produce a strip foundation of concrete. He is more dependable than a bar base, but requires greater financial and labor costs. Incidentally, the greenhouse, that is used in winter, without it and don’t do without it whatsoever.

Stages of the formation of a strip base: a schematic representation

Many producers advise to install greenhouse structures without even building a base. For this function, they equip the framework with special T-shaped legs, so that the construction was firmly fixed. But, as practice shows, it is still vital to construct a foundation: therefore and the foundation will be more firmly fixed and also the components of the basis that are in contact with the ground, will be stored much more in its initial condition.

The main issue is to treat the material with special agents to protect the timber from moisture. The substance is installed on concrete blocks which are dug into the ground. For a six-meter structure, they need 10 pieces: four on either side and one at the center of the endings.

Before you do the greenhouse itself, you have to choose the best spot for this. It must be an even website, so the frame was located equally, without distortions. It should be sunny and not obscured by trees or buildings.

gidpostroy.ru

Leave a Reply

Your email address will not be published. Required fields are marked *